Catch Can Issues
Thread Starter
Safety Car
Joined: Jul 2007
Posts: 4,456
Likes: 29
From: Wichita Falls Texas
Catch Can Issues
17 ZO6
Just installed headers, pulley, cam, Tx Speed CNC Heads, MM Catch can.
Got it dyno tuned and the next day it stared smoking white smoke out the exhaust on start up. Found the catch can pretty full of oil. I drained the can and got a half a cup full out. Smoke went a way. Couple days later less than 100 miles the can is full again and its smoking on start up.
Any help why its filling up so fast and sucking oil in is appreciated.
Just installed headers, pulley, cam, Tx Speed CNC Heads, MM Catch can.
Got it dyno tuned and the next day it stared smoking white smoke out the exhaust on start up. Found the catch can pretty full of oil. I drained the can and got a half a cup full out. Smoke went a way. Couple days later less than 100 miles the can is full again and its smoking on start up.
Any help why its filling up so fast and sucking oil in is appreciated.
Thread Starter
Safety Car
Joined: Jul 2007
Posts: 4,456
Likes: 29
From: Wichita Falls Texas
I did all the installation.
I did pull the oil lines. I pulled the motor to do the cam swap.
I filled it with 9.8 quarts. It actually still reads low but didn't want to overfill.
