Crane XE Cams
02-08-2005, 08:49 PM
#1
Crane XE Cams
I've been reading some bad posts on the Crane XE series of cams. I'm sorta sick reading them tonight as I just ordered in a new Comp Cam XE-274H-10. Many people have posted about premature wear problems in anything big block. Anyone have any success with these cams?
02-08-2005, 09:07 PM
#2
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
I had good success with a Comp XE flat tappet. Nice cam.
Half the people that badmouth parts either installed/adjusted it wrong,
or ordered the wrong part in the first place hoping it would run like "their buddy's car". That makes all parts a P.O.S.
Take it with a grain of salt....Crane's been around for a long time and also make a good line of products.
Half the people that badmouth parts either installed/adjusted it wrong,
or ordered the wrong part in the first place hoping it would run like "their buddy's car". That makes all parts a P.O.S.
Take it with a grain of salt....Crane's been around for a long time and also make a good line of products.
02-22-2005, 03:26 PM
#7
Drifting
Originally Posted by Indynut
I've been reading some bad posts on the Crane XE series of cams. I'm sorta sick reading them tonight as I just ordered in a new Comp Cam XE-274H-10. Many people have posted about premature wear problems in anything big block. Anyone have any success with these cams?
Bob
