When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Thanks to the commitment of a great bunch of guys The Vette Doctors.
My car finally hit the track and things are certainly going in the right direction. For everyone that is not familiar with the current mods. Here they are: The 4l60 has been replaced with turbo 400 in its stock location. The rear end was modified to act like a spool. A custom DTE brace was installed. My power plant is an ls2 block, C5R heads and a custom sheet metal manifold controlled by an Accel/DFI system. My power adder is a two stage Speed Tech Direct port nitrous system. All these changes at one time created one hell of a mission; we were plagued with many problems that needed to be worked out.
Now the results: Two 10.1 passes followed up with two 10.0 runs all N/A going thru the traps at only 3500 rpm. The motor ran flawless. The tranny worked perfectly (after being in and out at least 6 times) The convertor was way two loose flashing to almost 6,000 N/A ( that will be getting swapped out this week) The rear even stayed in one piece after some nice launches off the brake.
This car will have no problem running mid nines@ 3400lbs on motor with right gears and convertor.
Now for the best part!
The Doctors said that if I made thru the day with out braking. I could have my Bottles Back
Thanks to the commitment of a great bunch of guys The Vette Doctors.
This car will have no problem running mid nines@ 3400lbs on motor with right gears and convertor.
Now for the best part!
The Doctors said that if I made thru the day with out braking. I could have my Bottles Back
Paul, the car ran great for a shake down cruise. Like many others, I can't wait to see it on the bottle. Continued good luck with it and your racing season.
Joe
We will be starting small may be a 200 shot and working our way up. Looks like I will be running with the sh@tty convetor again. I wont be able to get the new one in time for sunday.
Not recommended for a car pushing less then 800 to the tire. The 4L60 holds up just fine. The swap requires modifications to youir X pipe and tranny tunnel.