Coolant Temp Gauge
#1
Burning Brakes
Thread Starter
Coolant Temp Gauge
Can you tell me on the back of the water
temp gauge on what screws the electrial prongs
go on and does any of the prongs need an insolator.
it's a 1975
Thanks
temp gauge on what screws the electrial prongs
go on and does any of the prongs need an insolator.
it's a 1975
Thanks
#5
Wires go where??
Since my car(a 72) is apart, I just went out to look for ya.
NO luck, mine has a connector(plug in type)
Sorry...anyway you'll go back to the top of the page now and 75'er can chime in here...lets hope!
Good luck! Dave
NO luck, mine has a connector(plug in type)
Sorry...anyway you'll go back to the top of the page now and 75'er can chime in here...lets hope!
Good luck! Dave
#6
Burning Brakes
Thread Starter
Yes I have the connector, what I need
to know is where the long metal prongs
go on the gauge, what the connector
plugs in to
and does any of them
have a isolator washer on them
Thanks
to know is where the long metal prongs
go on the gauge, what the connector
plugs in to
and does any of them
have a isolator washer on them
Thanks
#7
Racer
Member Since: Jan 2004
Location: cincinnati oh
Posts: 294
Likes: 0
Received 0 Likes
on
0 Posts
TPI,
Take a look at the gage cluster in this ebay auction:
http://cgi.ebay.com/ebaymotors/Corve...QQcmdZViewItem
It is a good example of what an original gage set up should look like. You can also enlarge the pics to show the insulators that go between the screw terminals and the gages. If your insulators are shot, use some small rubber washers instead. Hope this helps.
Take a look at the gage cluster in this ebay auction:
http://cgi.ebay.com/ebaymotors/Corve...QQcmdZViewItem
It is a good example of what an original gage set up should look like. You can also enlarge the pics to show the insulators that go between the screw terminals and the gages. If your insulators are shot, use some small rubber washers instead. Hope this helps.