half shaft
Thread Starter
Navigator
Joined: Mar 2008
Posts: 9
Likes: 0
From: NILES OHIO
half shaft
I have a u joint on the passenger side half shaft that needs replaced. can anyone give me hints on how to or web sites on this subject? I have replaced U joints on drive shafts before is this the same process or is there more to this task.
Le Mans Master
Joined: Mar 2002
Posts: 8,575
Likes: 3
From: On an island surrounded by sharks Hawaii
Team Owner
Joined: Jan 2006
Posts: 37,637
Likes: 3,118
From: Crossville TN
The 'toughest' part of this task is to break the old joints out of the yokes. Most are locked in place from rust/corrosion. If you have a press, set a fair amount of force on the joint with the press, then rap on the yoke journals with a small hammer (rap on them, don't pound on them). That will cause the corrosion to break loose and get them moving. After that, it's a 'piece of cake'.
Pro
Joined: Dec 2006
Posts: 665
Likes: 0
From: wilmington nc
When you jack the car up an let the rear tire hand down, not touching the ground. The halfshaft may come right out without even messing with the camber nut. Try it! Mine did 
I took mine to a local shop, fleet pride which installs truck u-joints. For 7.50 each they installed the new u-joints. 45 bucks to install 6 u-joints, they can have that job.
I took mine to a local shop, fleet pride which installs truck u-joints. For 7.50 each they installed the new u-joints. 45 bucks to install 6 u-joints, they can have that job.
Thread Starter
Navigator
Joined: Mar 2008
Posts: 9
Likes: 0
From: NILES OHIO
thanks again for all the help, i hope mine goes that well. The camber bolt was a worry but you guy's have put my mind to rest. Now if the weather lets up i can try all your information out.
