When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I want to change my rear diff. I believe it's 3:08 and want to go to 3:73. I have seen some posts on the best places to go and I have looked into it but can't remember the place. I believe it's in either Indiana or Ohio. Forget the guys name but remember it was $800 for a rebuilt 3:73. Any advise is appreciated. Thanks
I want to change my rear diff. I believe it's 3:08 and want to go to 3:73. I have seen some posts on the best places to go and I have looked into it but can't remember the place. I believe it's in either Indiana or Ohio. Forget the guys name but remember it was $800 for a rebuilt 3:73. Any advise is appreciated. Thanks
Duntov Motors is one of them. Google Duntov Motors for an address and phone number.
I want to change my rear diff. I believe it's 3:08 and want to go to 3:73. I have seen some posts on the best places to go and I have looked into it but can't remember the place. I believe it's in either Indiana or Ohio. Forget the guys name but remember it was $800 for a rebuilt 3:73. Any advise is appreciated. Thanks
3.73:1 will result in about 3000 rpm's at 60 mph. A lot of noise, poor gas mileage, and engine wear.
2025 C2 of the Year ('64-'66) Finalist - Unmodified
St. Jude Donor '03-'05-'06-'07-'09
I have always heard good things about Van Steel in Clearwater, FL. I plan on taking my numbers matching/correct 3.08 diff for a rebuild and gear set change, to a 3.55. About an 90 minutes from my home. So its a huge savings not having to crate and ship.
Don't buy a used diff unless you are 100% sure about it's condition. I bought a used 3.55 out of a '79 here on the forum. Advertised as "under 40k miles, quiet, like new" yada yada yada. Seemed OK on the bench. Roars like crazy at 60 mph. Gears look like new. I think it's a problem with one of the pinion bearings.
Last edited by mbeeman350; Jun 15, 2015 at 10:30 AM.