Shock Mount
Le Mans Master
Joined: Oct 2006
Posts: 7,123
Likes: 433
From: Gladstone MO
C3 of Year Finalist (appearance mods) 2019
I used a big C-clamp just over the shock mount so I didn't spread the ears on the rear bearing support, then applied a little heat- not enough to make anything red, but way more than I wanted to hold on to. I put the castle nut on backwards before I heated it and then smacked it with a 3 lb brass hammer. Turned out it was stuck in the sleeve in the strut bushing and took a lot more effort. I was more concerned about killing the bearing support than the shock mount. Those are cheap compared to bearing supports.
2026 Loser of the Year
Joined: Sep 2013
Posts: 36,594
Likes: 7,041
From: New Or-leens Loo-z-anna
My '68 shock mount has a notch that must be aligned with the flat area inside the ARMS for the mount to go all the way in place. You may has to use sandpaper on the shock mount stud and inside the ARMS holes along with antiseize the other member mention. Then the mount stud should fit fully in place by using the nut and flat washers to draw it into place.
