Starter
Thread Starter
Racer
Joined: Dec 2012
Posts: 487
Likes: 66
From: Rhode Island
Starter
Hi every ones so I wanted to go for a ride with my 70 money Pitt every thing new but when I turned the key all I heard was the 6 month old starter just spinning no contact with the motor so I think I have to buy a new one,AGAIN thanks again bob
Race Director
Joined: Nov 2006
Posts: 13,068
Likes: 7,678
From: Sunshine Coast, Queensland, Australia
2025 C3 of the Year Finalist - Modified
2024 C3 of the Year Finalist- Modified
2022 C3 of the Year Finalist - Modified
Cruise-In VIII Veteran
Yes NAPA should have a bendix. Fairly easy to replace.
Le Mans Master
Joined: Mar 2004
Posts: 7,423
Likes: 1,458
From: Little Rock AR
The bendix is pretty cheap and easy to replace. The solenoid has 2 screws holding it on. The starter has 2 thru bolts holding it together. The bendix has a snap ring holding it on the end of the shaft.
The brushes are not that bad but you need them in place first at reassembly. Use 2 pairs of pliers to
reassemble the shaft snap ring cover.
Maybe 15 minutes once you have it on the bench.
The brushes are not that bad but you need them in place first at reassembly. Use 2 pairs of pliers to
reassemble the shaft snap ring cover.
Maybe 15 minutes once you have it on the bench.
Le Mans Master
Joined: Aug 2017
Posts: 8,336
Likes: 2,809
From: Cool Northern Michigan
While the bendix is off, good time to swap it out.
Purchasing a more expensive unit with a Ceramic (brown) end cap is a good investment. Handles heat much better.
But first: Photograph and label the small wires to the solenoid (with masking tape & a Sharpie) their location before removal.
Purchasing a more expensive unit with a Ceramic (brown) end cap is a good investment. Handles heat much better.
But first: Photograph and label the small wires to the solenoid (with masking tape & a Sharpie) their location before removal.
Last edited by HeadsU.P.; Aug 31, 2022 at 04:46 PM.
