Computer Command Diagnosis Code
Burning Brakes
Joined: Nov 2005
Posts: 1,143
Likes: 0
From: Leander Texas
I believe the ground wire is the gray (it could also be black) wire in the harness that goes to the map sensor connector. This wire is also spliced to the throttle position sensor. This wire goes to the (b) connector, terminal pin 11 on the ECM.
Thread Starter
Racer
Joined: Nov 2002
Posts: 364
Likes: 0
From: Potomac MD
Thanks for the help it’s working now. I checked the fuses all good then I started a continuity test from the injectors back everything was good to the firewall; still no signal to rear injector. Pulled the connectors from the ECM and checked/cleaned them; still no signal to rear injector. I pulled the fuses again tested them and they were good. Then I noticed the prongs on the fuses were a little dirty looking so I sanded them with 320 wet/dry sandpaper and put them back and both injectors worked perfectly. Man, I’ve been troubleshooting this off and on for a week; I knew sooner or later I’d get it. It was running fine one day then the next not. Thanks for all the help.
