When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Nice work on the dash! I would like to have something similar for my C3. You could just put a Racepak in there. What are your plans for instrumentation?
Body is back on the chassis. The 7qt oil pan sat too low, so we swapped it out for a Moroso 6 qt, and only had to drop the steroids rack and pinion by 3/4". Fuel lines are plumbed. Alternator is installed. Kind of a pain to find a mid mount that would fit. Not too much left before we can fire the engine. Most time consuming will be modifying the drive side header similar to what we did for the passenger.
Outstanding!
This thing should be capable of low 9's-high 8's you reckon?
Jebby
No clue. It has a tight converter and a 3.50 rear gear to tame it down on the street, so it’s not going to be a 1/4 mile beast. But it’ll be a riot around town.
No clue. It has a tight converter and a 3.50 rear gear to tame it down on the street, so it’s not going to be a 1/4 mile beast. But it’ll be a riot around town.
Got some more work done. Finished the driver's side header and made some side pipes. Couldn't find anything that would reduce the noise level and not hinder performance. Largest side pipes we could find were 3.5" and we needed a true 4" so the engine wouldn't get choked out. So......we welded two resonators together and then filled the gap between them. Turned out pretty good in my opinion. They'll be ceramic coated along with the headers.
07-19-2018, 09:06 PM
