ATIS

I have the replacement electric board for the tach, how do I repalce it? Can I get to it without pulling the dash or is the dash coming out my only option?

hunt4cleanair

Your only option is dash removal. It wasn't until 78 when Corvette changed the configuration to permit board access from the tach/speedo cluster.

Wilcox (CF sponsor) offers some comprehensive instructions for 75-77 owners who wish to tackle this. I did my 78...but than it was a calkwalk coompared to your task. Once you get it installed, be prepared to start the car and check performance before re-assembling the entire dash. May save yourself some headaches.

PS...if the board you have to install is lacking specific instructions...let us know or drop me an email. You may also wish to explore past discussion threads on the topic to ensure its installed correctly and without incident. You don't wont' to have to tear into that dash again.

ATIS

I did a search and didnt find any threads. I bought the Wilcox board so I will check their site for a tech article.

Thanks for the heads up on testing before assembly.

0Willcox Corvette

http://willcoxcorvette.com/repairand...lp.php?hID=290
Corvette Tachometer Testing, Removal, Board Installation, Video Link 1975-1982

http://willcoxcorvette.com/repairand...lp.php?hID=314
Corvette Tach Filter Installation Instruction Sheet Revised 3-11

http://willcoxcorvette.com/repairand...lp.php?hID=318
Corvette Left Hand Dash Pad Removal Made Easy 1968-1977

Corvette Tachometer Board Installation Instructions 1978-1982
http://willcoxcorvette.com/repairand...lp.php?hID=252

Corvette Tachometer Testing, Removal, Board Installation, Video Link 1978-1982
http://willcoxcorvette.com/repairand...lp.php?hID=290


1978-1982


1975-1977

hunt4cleanair

You're in good shape than.

Many vendors get their boards made overseas and there have been installation problems in the past. Not sure if that's still the case but Wilcox has his made and assembled here...its a "made in USA" service replacement part.

Wilcox...do you make these for other GM brands?

ATIS

Wilcox, thanks for the videos, never would have thought to zero her out.

Hunt, good to know about the parts.

0Willcox Corvette

Tom-

The only other bridge we crossed with this was the board for the 1975-1986 chevy trucks. We made a few, advertised them, offered them to truck vendors and no one bit. There is not a manufacture of that board anywhere its that the production of the trucks with a tach was such a low production. I'm told our board will fit a Nova with some mods but I've not ventured there yet.

As long as I'm verticle and breathing our boards will be made here in the USA.