c3 power steering
Thread Starter
8th Gear
Joined: Oct 2012
Posts: 8
Likes: 0
From: ohio
c3 power steering
I was curious if I can replace the bushing only thats on top of the power steering assist valve, I found the rebuild bushing kits for the PS cylinder which I also need but cant seem to find kits for the valve stud that goes into the bottom pitman arm slot. Any help is appreciated
Team Owner
Joined: Jan 2006
Posts: 37,637
Likes: 3,118
From: Crossville TN
If you are referring to the 'snubber' bushings at the [frame mounted] end of the slave cylinder, sure. When they get old/hard/compressed, it is time for them to be changed. The rubbers are the same stuff used for shock absorbers; if you can reuse the washers, just replace the rubbers.
Can't help you with a source for the ballstud replacements.
Can't help you with a source for the ballstud replacements.
