Ride height advise.
Thread Starter
Racer
Joined: Oct 2006
Posts: 412
Likes: 1
From: St. John's Newfoundland
[QUOTE=7t9l82;1589151568]i cut 3/4 of a coil and while it is exactly what i wanted it may be low for some people. a guy that did spring work for over 40 years told me if you want to drop a coil " a good rule of thumb" is measure your wheel well height and decide where you want it then cut that much off the total height of the spring. i decided on a 2 1/2" drop and cut that off the total height of the coil which ended up being 3/4 of a coil. personally id start at 1/2 a coil and see if thats what you want. i cut one end of the spring.
[/QUOTE ]
So you just let your spring relax and measured what u needed cut? I think I'll give it a go. I'll let you guys know how it works out.
Thanks again'
Clyde
[/QUOTE ]So you just let your spring relax and measured what u needed cut? I think I'll give it a go. I'll let you guys know how it works out.
Thanks again'
Clyde
Le Mans Master
Joined: Oct 2010
Posts: 6,930
Likes: 845
From: melbourne florida
2023 C3 of the Year Finalist - Modified
VBP has 10" bolts that are threaded maybe 5" to make adjusting easier. if you have them made get some nylock nuts to make sure the don't get loose.
