clutch problems
Thread Starter
Pro
Joined: Oct 2007
Posts: 549
Likes: 5
From: punta gorda florida
clutch problems
won't release installed new clutch stage 2, suppose to have stronger clamping or holding power but will not release tried longer release bearing was way to long. any ideas 1969 350 4speed
checked disc installed ok
checked new pressure plate and old for any difference in for size height distance comparison from bellhousing to diaphragm
old was 2.3 from front face of bellhousing
new was 2.5 so it to me would be closer
any ideas
also new flywheel
also as many comparison measurements as I could all seem to be very much the same
Its a phoenix friction stage 2 set up
checked disc installed ok
checked new pressure plate and old for any difference in for size height distance comparison from bellhousing to diaphragm
old was 2.3 from front face of bellhousing
new was 2.5 so it to me would be closer
any ideas
also new flywheel
also as many comparison measurements as I could all seem to be very much the same
Its a phoenix friction stage 2 set up
Tech Contributor
Joined: Aug 1999
Posts: 14,370
Likes: 6,361
From: At my Bar drinking and wrenching in Lafayette Colorado
Make sure you check out my article here about clutches that won't release:
https://www.corvetteforum.com/forums...and-specs.html
Lars
https://www.corvetteforum.com/forums...and-specs.html
Lars
