Usual leaks and replacement items + tool
Thread Starter
Pro
Joined: Nov 2017
Posts: 587
Likes: 49
From: Belgium
Sooooo, finaly at my place!
Ever driven a corvette without brakes? ( handbrake really didn't do much either).
Only a 3km drive, but without doors and brakes it was scary enough! Lost the rear left wheel after 800 meter! Wich ground the strut rod and rear wheel bearing support flat. Hope I can build it up with some weld.. Will have to see tomorrow morning. But it's home.
Ever driven a corvette without brakes? ( handbrake really didn't do much either).
Only a 3km drive, but without doors and brakes it was scary enough! Lost the rear left wheel after 800 meter! Wich ground the strut rod and rear wheel bearing support flat. Hope I can build it up with some weld.. Will have to see tomorrow morning. But it's home.
Thread Starter
Pro
Joined: Nov 2017
Posts: 587
Likes: 49
From: Belgium
Wheelnuts came off (obviously haha).
No idea why though! I suspect the new wheel nuts ( a shame to but shiney chrome on the car atm but hey). Are a tad too long/shallow, and bottom out before they clamp the wheel properly, as I always religiously torque wheelnuts to spec :p
No idea why though! I suspect the new wheel nuts ( a shame to but shiney chrome on the car atm but hey). Are a tad too long/shallow, and bottom out before they clamp the wheel properly, as I always religiously torque wheelnuts to spec :p
Thread Starter
Pro
Joined: Nov 2017
Posts: 587
Likes: 49
From: Belgium
