Need some problem solving ideas....
Thread Starter
Race Director
Joined: Apr 2000
Posts: 11,840
Likes: 0
From: Galloway NJ
Need some problem solving ideas....
I have an emblem that I need the threaded studs to be about 2 inches longer. I need ideas on making them longer, and be stong enough to withstand extreme vibrations over long periods of time :D
Thread Starter
Race Director
Joined: Apr 2000
Posts: 11,840
Likes: 0
From: Galloway NJ
Re: Need some problem solving ideas.... (1969c3mandy)
get the long threaded nuts with the big nut at the end. worked for me...
which emblem?
which emblem?
Melting Slicks
Joined: Dec 2000
Posts: 3,407
Likes: 2
From: Carmichael CA
Re: Need some problem solving ideas.... (Metal_Wulf)
Is the threaded stud a large enough diameter to say drill out 1/64" and then tap it to like 22 threads per inch and install a 2" long jewelers screw? Another possibility is to loop some thin wire around it and then thread it through your mounting surface and attach it somewhere inside...it may be sloppy this way, but a little rubber cement or something other surface contact glue would keep it from sliding around.
