82 help needed
Thread Starter
Heel & Toe
Joined: Dec 2003
Posts: 15
Likes: 0
From: FT. LAUDERDALE FL
82 help needed
Car had been parked for a year, brought it home got it started, ran rough like water in the gas, new gas.
Now it will not start, am getting very intermintent spark (enough to light a timming light off #1 wire, I checked three other wire's and got a lite spark off one)
When I crank the engine with out touching the gas pedal the fuel injectors spray fuel constently into the throttle bodies, when I crank the engine with the pedal to the floor the fuel injectors pluse fuel in?
I have replaced everything in the Distributor (cap, coil, module, pick up coil, roter)
What to do next? Advice needed
Is there a link to a Crossfire injection forum?
Thanks
Now it will not start, am getting very intermintent spark (enough to light a timming light off #1 wire, I checked three other wire's and got a lite spark off one)
When I crank the engine with out touching the gas pedal the fuel injectors spray fuel constently into the throttle bodies, when I crank the engine with the pedal to the floor the fuel injectors pluse fuel in?
I have replaced everything in the Distributor (cap, coil, module, pick up coil, roter)
What to do next? Advice needed
Is there a link to a Crossfire injection forum?
Thanks
Le Mans Master
Joined: Aug 2000
Posts: 9,662
Likes: 7
From: Semper ubi, sub ubi
Cruise-In VI Veteran
Cruise-In VII Veteran
Re: 82 help needed (PARKS)
Yes there is a Crossfire Forum, it is run by one of the Corvette Forum Members. I saw a post the other day that there were some problems with the Xfire forum and it was being worked on.
Here's the last address I have for the Crossfire Forum
http://www.crossfire.homeip.net:81
Here's the last address I have for the Crossfire Forum
http://www.crossfire.homeip.net:81
Race Director
Joined: Jan 2003
Posts: 15,175
Likes: 86
From: State of Confusion
Racer
Joined: Nov 2002
Posts: 364
Likes: 0
From: Potomac MD
Re: 82 help needed (PARKS)
I did the same thing you did, replaced everything in the distributor. Then I looked at my distributor cap and noticed it came without a ground (center slot). I could not keep the engine running. Went back to parts store and bought the center ground connecter and she fired right up.
