Help with a code 36
Thread Starter
Melting Slicks
Joined: Jul 2000
Posts: 2,801
Likes: 2
From: Amarillo TX
Help with a code 36
I've got a friend with an 89 coupe that keeps setting a code 36. I've gone through all my books and can't find a code 36 for an 89 model.
Any ideas?
Thanks,
Dave
Any ideas?
Thanks,
Dave
Melting Slicks
Joined: Aug 1999
Posts: 2,240
Likes: 42
From: Baltimore, MD USA
After the engine is shut off, the Mass Airflow Burn off relay should close for a couple of seconds to burn off any impurities on the MAF sensing wire.
If you open the hood and look at the driverside firewall behind the battery, you'll see two relays.
The one closest to the drivers door is the MAF Power relay. The one next to it is the Burn Off relay.
On a 89 the relays are the same. He might as well replace both relays at the same time.
If you open the hood and look at the driverside firewall behind the battery, you'll see two relays.
The one closest to the drivers door is the MAF Power relay. The one next to it is the Burn Off relay.
On a 89 the relays are the same. He might as well replace both relays at the same time.
Burning Brakes
Joined: Aug 2001
Posts: 896
Likes: 1
From: Oro Valley AZ
Just went through the same thing on my 86 and I just replaced both of the relays bought from GM at about 30 for the pair. Also make sure he checks the wires going into the connectors as I had a couple that were bare for almost 3/4 an inch from the connector. Fixed that and the new relays and problem was solved. Hope that helps.
Race Director
Joined: Dec 1999
Posts: 11,182
Likes: 2
From: Almost all Skyline Cruises Vettes at Waterside 1-5
Cruise-In I Veteran
Cruise-In II Veteran
Cruise-In III Veteran
Cruise-In IV Veteran
Cruise-In V Veteran
Cruise-In VI Veteran
Cruise-In VII Veteran
Originally Posted by R-D Racing
I've got a friend with an 89 coupe that keeps setting a code 36. I've gone through all my books and can't find a code 36 for an 89 model.
Any ideas?
Thanks,
Dave
Any ideas?
Thanks,
Dave
also, find some electrical connector cleaner or just some 93% Isopropyl alcohol and douse the electrical onnections (male and femal) at the MAF
seey
