I have this configuration on the 383 going in the vette. It is a one peice rear main seal block with a two peice crankshaft. I forget who made the adaptor.
1pc or 2pc??
Thread Starter
Racer
Joined: Feb 2008
Posts: 435
Likes: 0
From: Bulverde TX
1pc or 2pc??
Ok so the L98...1 peice rear seal or 2 peice rear seal? I have been wondering this since the day i started looking at stroker kits because that seems to be the big question.
Racer
Joined: Jun 2002
Posts: 443
Likes: 0
From: Pueblo Colorado
Isn't it that some 86s are 1 and some 2???
If aluminum heads and roller cam then 1pc???
Earlier 86s with iron heads 2pc???
Convertables all 1pc???
I could be wrong but alot of things seem to have been mixed up in the 86s.
If aluminum heads and roller cam then 1pc???
Earlier 86s with iron heads 2pc???
Convertables all 1pc???
I could be wrong but alot of things seem to have been mixed up in the 86s.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Le Mans Master
Joined: Dec 2002
Posts: 5,270
Likes: 3
From: Seattle Area WA
Yep, but obviously to do it right with your 85 block, you need a 2-piece. (Assuming it is stock.)
However, depending on your plans it might be worth 250$ to pick up a new 1pc block set-up for a roller cam. The cost of a retro-fit conversion is much more expensive than the cost of a used 350 core.
However, depending on your plans it might be worth 250$ to pick up a new 1pc block set-up for a roller cam. The cost of a retro-fit conversion is much more expensive than the cost of a used 350 core.
Drifting
Joined: Dec 2005
Posts: 1,360
Likes: 3
From: NORTHEAST
Yep, but obviously to do it right with your 85 block, you need a 2-piece. (Assuming it is stock.)
However, depending on your plans it might be worth 250$ to pick up a new 1pc block set-up for a roller cam. The cost of a retro-fit conversion is much more expensive than the cost of a used 350 core.
However, depending on your plans it might be worth 250$ to pick up a new 1pc block set-up for a roller cam. The cost of a retro-fit conversion is much more expensive than the cost of a used 350 core.
