will code 24 (mph stuff) put comp into limp mode?
Thread Starter
Drifting
Joined: Dec 2007
Posts: 1,672
Likes: 8
From: Sumter South Carolina
will code 24 (mph stuff) put comp into limp mode?
I'm getting a code 24 which is something to do with speed sensor. I just sent my dash off to be refurbished and I'm hoping that is what is setting the code. will this code being set put the comp into some sort of limp mode like it would with a bigger problem, or does it only do that for things like low fuel pressure, MAF, stuff like that? I think I'm just imagining the loss of drivability when it pops up.
Le Mans Master
Joined: Jul 2007
Posts: 5,043
Likes: 8
From: Tampa Florida
I'm getting a code 24 which is something to do with speed sensor. I just sent my dash off to be refurbished and I'm hoping that is what is setting the code. will this code being set put the comp into some sort of limp mode like it would with a bigger problem, or does it only do that for things like low fuel pressure, MAF, stuff like that? I think I'm just imagining the loss of drivability when it pops up.
Le Mans Master
Joined: Aug 2000
Posts: 8,838
Likes: 31
From: Australia
Typically these things will happen.
1.)Your IAC will not reset and your idle will be unstable
2.)Decel fuel cut will not work and your engine will load up as you coast to a stall and even stall.
3.)The IAC throttle follower routine will become messed up. It will act like the throttle plates are hung open and keep motoring on for a couple of seconds when you let off the gas
1.)Your IAC will not reset and your idle will be unstable
2.)Decel fuel cut will not work and your engine will load up as you coast to a stall and even stall.
3.)The IAC throttle follower routine will become messed up. It will act like the throttle plates are hung open and keep motoring on for a couple of seconds when you let off the gas
