I'm confused
Thread Starter
Drifting
Joined: Nov 2001
Posts: 1,587
Likes: 0
From: Omaha NE
I'm confused
After I got my long tubes, plugs, wires, and MSD 6A installed my car has been throwing code 64(Lean, O2). What do you think caused this, and is there any quick fix so I can get my car running better?
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: I'm confused (BAdAzZV8)
Bad, all three of your 02 sensors should be heated(unless they were replaced by non heated)
Thread Starter
Drifting
Joined: Nov 2001
Posts: 1,587
Likes: 0
From: Omaha NE
Re: I'm confused (Mr Mojo)
Yep, they're all heated.
Do you guys know how many wires the sensor plug(into the block between plug #'s 6 & 8). Mine only has one wire plugged into the back of it, but it looks as if there should be two wires(I think mine's green).
Do you guys know how many wires the sensor plug(into the block between plug #'s 6 & 8). Mine only has one wire plugged into the back of it, but it looks as if there should be two wires(I think mine's green).
