bench bleeding a brake master cyinder
03-18-2011, 07:10 PM
#1
Race Director
Thread Starter
Member Since: Aug 2002
Location: tucson AZ
Posts: 13,356
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Donor '04 & '05
bench bleeding a brake master cyinder
what are the fitting sizes (2 different) to make up a bench bleeder for my master cylinder? can not find a kit just to do the master cylinder which is new from Wagner...brand spanking new from rock auto. no bleeder in the kit.
thanks for the help?
thanks for the help?
03-18-2011, 07:44 PM
#2
if you dont mind a little mess , you can cover the holes with your fingers, pump the piston, while the piston is pushed in cover the holes tightly with your fingers, release the piston and repeat probably 4-5 times, use a towel to catch the fluid and a clamp of some sort to hold the M/C. ......
no school like old school
no school like old school
03-18-2011, 11:46 PM
#3
Instructor
Member Since: Oct 2010
Location: Lakeside AZ.
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
if you dont mind a little mess , you can cover the holes with your fingers, pump the piston, while the piston is pushed in cover the holes tightly with your fingers, release the piston and repeat probably 4-5 times, use a towel to catch the fluid and a clamp of some sort to hold the M/C. ......no school like old school
no school like old school
