Intake gaskets.
Thread Starter
Drifting
Joined: Dec 2000
Posts: 1,785
Likes: 91
From: Leander TX
Intake gaskets.
What kind should I get and where should I get them. I have 155K miles on the original ones and since I have a severe oil leak and am putting in new injectors I thought I should do this to. About how much do they cost too. Thanks.
Melting Slicks
Joined: Apr 2000
Posts: 2,793
Likes: 46
From: Elizabeth City, NC
Re: Intake gaskets. (85WHITEZ51)
You can either go to your local auto parts store or order them from Summit or Jegs. You don't need anything more than the stock ones at this point. Just make sure you get Felpro gaskets and you will be fine. If you want to order them from Summit the felpro part number for your car is 1204.
Thread Starter
Drifting
Joined: Dec 2000
Posts: 1,785
Likes: 91
From: Leander TX
Re: Intake gaskets. (LPDesRoche)
Thanks LPDesRoche, I really appreciate it. Didn't know if it was a special order part from somewhere or if I could go to NAPA or AutoZone and get them.
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: Intake gaskets. (85WHITEZ51)
I got the FlePro Intake Manifold Gasket Set #MS 93318 from Auto Zone for about $35. It fits '86-'93 350 engines, so you need a different set. I expect your set will have similar contents:
(1) Black RTV, to seal the front & rear rails.
(1) Throttle body gasket
(1) dist. gasket
(1 each) fuel feed & return O-rings
(8) fuel injector O-rings
(1 each) plenum left & right side runner gaskets
(1 each) intake base left & right side runner gaskets
(1 each) intake base left & right head gaskets
(1) Black RTV, to seal the front & rear rails.
(1) Throttle body gasket
(1) dist. gasket
(1 each) fuel feed & return O-rings
(8) fuel injector O-rings
(1 each) plenum left & right side runner gaskets
(1 each) intake base left & right side runner gaskets
(1 each) intake base left & right head gaskets
