Clutch Problem
Thread Starter
Pro
Joined: Mar 2000
Posts: 632
Likes: 0
From: Medina, Ohio
Clutch Problem
My car will not go in gear. I've bled the slave cylinder a couple of times and have about .67 travel at the fork. The fluid was really low so I figured air in the system. I only have 27k on the car so I don't think it's the clutch . Am I not getting the air out? (I did exactly what the manual says). The car was running fine. I went to trace a fuse link for the blower motor, finished put the car back on the ground and could not get it in gear.
Can anybody give me any insight here.
Thanks, Dan
Can anybody give me any insight here.
Thanks, Dan
Race Director
Joined: Feb 1999
Posts: 12,772
Likes: 17
From: Indianapolis IN
Re: Clutch Problem (dans86)
Have someone push in the on the clutch peadal but before hand get under the car and pull away the rubber boot where the hydraullc push post engages the clutch arm. If the arm is moving the distance then its the clutch. If the arm is barely moving your slave (1st) is probably going or possibly the master cylidner.
