Hole-Shot

I need to find a spare Memcal/Calpak so I can have a custom chip burned.
Does anyone have one that they would sell me?
Here is a picture of the stock chip in my 87. Do I have to get one with the same "abtf" code? Any tips/pointers will also be appreciated. Thanks!

Guest

I have been going through the same thing but found some part #'s.

I believe the part # for your 87 EPROM is: 16070733

This is for an 87, A-Trans, 3.07 rear

Try GMpartsdirect.com, I plugged in the number and it came up around 30 bucks.

HTH,
Mark

Hole-Shot

Thanks for the tip!
Still would like to find a used one if possible.


BTW, Nice looking motor! :cool: Have you ever ran it in the 1/4 mile?


[Modified by Hole-Shot, 2:17 PM 9/28/2002]

Muffin

David are you looking for a used EPROM to have burned?

VetteNoob

Give Jeff Kopp a call. I dont think they are very expensive.

http://www.superchevyperformance.com/about.html

Hole-Shot

YES! That is what I need it for. Do you have one?

Muffin

Found a supply of used ones last week. e-mail me your requirements.

Guest

________________________________________ _______________
Quote:
BTW, Nice looking motor! Have you ever ran it in the 1/4 mile?
________________________________________ _______________

Did last night, new to drag racing so my Reaction Time is slow and I'm on street tires;

12.77 sec/114.8 MPH (1.18 sec RT) was my best.

ZylaRace

GM P# for an 87 Vette MemCal 16070312
The EPROM does not have to match, by the MemCal needs to be correct for the engine/trans combo. There is a ResPack that tells the ECM what engine/trans/rear gears it is working with.

Just don't expect to us a V6 MemCal in a V8 application. All bets are off that it will not show a problem.