Installing crankshaft position sensor reluctor rings????
Thread Starter
Racer
Joined: Jan 2002
Posts: 419
Likes: 0
From: Tampa FL
Installing crankshaft position sensor reluctor rings????
It presses on the the crank with the keyhole, but seems loose. What is the best way to insure it is installed correctly and snug?
Thanks MAx
Thanks MAx
Race Director
Joined: Apr 2000
Posts: 15,344
Likes: 4,009
From: Texas
Re: Installing crankshaft position sensor reluctor rings???? (MaddMaxx)
It fits loose. The hub seats against it and holds it in place. You'll note the reluctor ring is machined such that it should only be installed one way. Press it flush against the crank sprocket and if it contacts the timing chain, then flip it. Bascially the "convex" side goes torwards the engine/crank sprocket and the "concave" side points out.
Le Mans Master
Joined: Jan 2003
Posts: 8,596
Likes: 19
From: Portland Oregon
Re: Installing crankshaft position sensor reluctor rings???? (MaddMaxx)
Max if you are planning on using a stock style hub without a key way. You can leave the key in the crank and just file it down to the surface of the crank just like the original. Basically the key has to locate the reluctor ring and from that point on its even with the top of the crank.
