Dyno # guesses?
#21
Pro
Wouldn't be that hard. I made 680/600 on 93 with an old *** V2 S-trim, spinning to 12lbs on a stock cube LS6. If i dropped my pulley size to get more flow down low, I'm sure I could have gotten the torque in that area.
#22
Drifting
Member Since: Nov 2011
Location: Chesterfield (St. Louis) MO
Posts: 1,377
Received 40 Likes
on
34 Posts
I didn't word that very well... What I should have said, was that the torque would most likely not be matching the peak HP at stock cubes, when putting down 637 WHP or so, unless the top end is "neutered". You certainly could make 637 WTQ with the stock cubes, but the power would be over 700 WHP.
#23
Pro
I didn't word that very well... What I should have said, was that the torque would most likely not be matching the peak HP at stock cubes, when putting down 637 WHP or so, unless the top end is "neutered". You certainly could make 637 WTQ with the stock cubes, but the power would be over 700 WHP.
#26
Platinum Supporting Vendor
Way to go man! I wasn't too far off on my guess of 699rwhp
#27
Thanks for a great product and all of the help yall have given me the last few weeks! (I kept calling yall about running a 8 rib pulley with a 6 rib belt lol).
The only thing that worries me is the 20* of timing. Seemed a tad high.
#29
Platinum Supporting Vendor
Well it is a forged bottom end right? What's the CR?
If you're nervous take 2* off the top for a little cushion.
If you're nervous take 2* off the top for a little cushion.
#30