[Z06] Partition question
Drifting
Joined: Feb 2007
Posts: 1,993
Likes: 7
From: LaPine Oregon
partition dimensional drawing
Was the drawing accurate? well close enough for government work. I layed out a templete that was one (1) inch oversize ( height and length) and then trimmed to fit . I have three working cardboard templetes/patterns now that I use. I have found that there are differences , though small or slight between years and models. I mostly fabricate FRCes and Z06es.
Anyone contemplating a DIY partition and wanting to use this drawing I recommend doing the same as I do.
My partitions are two (2) inches thick which may account for some variation in fitment.
Anyone contemplating a DIY partition and wanting to use this drawing I recommend doing the same as I do.
My partitions are two (2) inches thick which may account for some variation in fitment.
