TPMS Sensor Training Concern
Thread Starter
Instructor
Joined: Nov 2002
Posts: 105
Likes: 7
From: Nicholasville KY
TPMS Sensor Training Concern
I recently bought a new set of Schrader sensors (#28006) from Tire Rack for my '98 Corvette.
I then wanted to check them out prior to installing, by attempting to train them, in place of current ones installed.
Was wasn't able to get any of the four to respond to the magnet I was using, yet the that same magnet works
with the current installed sensors.
Is there a problem with attempting to train with already installed sensors?
Is my magnet not strong enough for these newer redesigned sensors?
Is there a problem with my new sensors?
How do I very my sensors function prior to installing?
Thanks for any guidance or suggestions.
I then wanted to check them out prior to installing, by attempting to train them, in place of current ones installed.
Was wasn't able to get any of the four to respond to the magnet I was using, yet the that same magnet works
with the current installed sensors.
Is there a problem with attempting to train with already installed sensors?
Is my magnet not strong enough for these newer redesigned sensors?
Is there a problem with my new sensors?
How do I very my sensors function prior to installing?
Thanks for any guidance or suggestions.
