Help With TPMS Training
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 3,479
Likes: 93
From: Between Tally and Gatorville ,Florida
Help With TPMS Training
I have upgrade my 99 tpms to the 01-04 set up but while training the fob and tpms I can only get up to the fob. The fob trains just fine. However, I can't get passed the fob training to train the tpms. After I press the reset for 3 seconds, I get fob training,when I press the option button to move me to the tpms,it just stays on the fob. I've checked fuse 27 and it's ok.
wire to receiver connector are
blk/white to pin4, pin ope, pink to pin 2 and orange to pin1
I'm using a new connector.
I've seen this issue before but,I can't seem to find the tread on it.
wire to receiver connector are
blk/white to pin4, pin ope, pink to pin 2 and orange to pin1
I'm using a new connector.
I've seen this issue before but,I can't seem to find the tread on it.
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 3,479
Likes: 93
From: Between Tally and Gatorville ,Florida
Are you certain that you have the wires on the correct pins of the RFA?
Look into the end of the port on the RFA itself. You will see numbers that are below the pins. The numbers are left to right 4 3 2 1.
The colors of the wires and the pin numbers on the RFA are
4 = Black/white = ground
3 = Open
2 = Pink = Serial Data buss
1 = Orange = Battery Positive Voltage.
I am not certain if the connector you receive with the kit has pin numbers on it.
This info is from an 04 shop manual.
If you want the wiring diagram and connector image I can post it.
Look into the end of the port on the RFA itself. You will see numbers that are below the pins. The numbers are left to right 4 3 2 1.
The colors of the wires and the pin numbers on the RFA are
4 = Black/white = ground
3 = Open
2 = Pink = Serial Data buss
1 = Orange = Battery Positive Voltage.
I am not certain if the connector you receive with the kit has pin numbers on it.
This info is from an 04 shop manual.
If you want the wiring diagram and connector image I can post it.
I reinstalled the old box and it worked like is suppose to.
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 3,479
Likes: 93
From: Between Tally and Gatorville ,Florida
Same exact issues. Returning the receiver in the morning for a replacement.
Thread Starter
Melting Slicks
Joined: Jul 2010
Posts: 3,479
Likes: 93
From: Between Tally and Gatorville ,Florida
No luck with the used replacement Receiver. still have the same issue. Reinstalled the 99 set up and all works as it suppose to. I think I'm going to purchase a new receiver rather than screw around with use crap! Unless someone has a suggestion.
