Drill Mod ? Need Help
Thread Starter
Pro
Joined: Jan 2000
Posts: 652
Likes: 3
From: Salisbury MD.
MASTER CYLINDER Drill Mod ? Need Help
I am replacing my slave and master and installing a spec 3. Do I need to do the drill mod ? On the f-body they drill the end going into the master. The restriction on the Vette is where it couples to the slave. Is that were you do the drill mod on the master end ?
Thanks, Jim
Thanks, Jim
Last edited by C5-JIM; Nov 14, 2005 at 11:05 PM.
Melting Slicks
Joined: Mar 2003
Posts: 3,116
Likes: 10
From: Macomb MI
The big rerstriction on the C5 is there the hose goes into the slave asm.
Just remove the roll pin and pull the line out. Once its out look in the end you just removed and all will be revealed
Phil
Just remove the roll pin and pull the line out. Once its out look in the end you just removed and all will be revealed
Phil
