weird
Thread Starter
Drifting
Joined: Sep 2001
Posts: 1,651
Likes: 0
From: Ocean County NJ
weird
Has anyone ever had there horn beep and unlock after arming the alarm and walking away? The door unlocks whether armed with key or fob. Any insight?
Thanks & happy holidays!
Thanks & happy holidays!
Last edited by skidmarc; Dec 23, 2005 at 09:41 AM.
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
sounds like you have a BCM issue. Check for any codes. If you have any, clear them and see if that helps. if it doesnt, disconnect the battery and let everything reset. If that doesnt do it, my next recommendation would be to chech the BCM for corrosion on the board inside the box in the passengers foootwell. Thats what happened to mine.
bill
bill
Thread Starter
Drifting
Joined: Sep 2001
Posts: 1,651
Likes: 0
From: Ocean County NJ
Bill,
Do I just disconnect the positive? 10 minutes good enough for a reset? I just put a new battery in the FOB and thats when the issue started so I pulled the battery from FOB and reprogrammed FOB again, so will see when I go out in a lil bit how it is.
Thanks
Do I just disconnect the positive? 10 minutes good enough for a reset? I just put a new battery in the FOB and thats when the issue started so I pulled the battery from FOB and reprogrammed FOB again, so will see when I go out in a lil bit how it is.
Thanks
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
If you installed a new battery in the FOB,, you MUST do a FOB relearn procedure. It should be in the owners manusl.
Re-syncing just wont work. You must re-learn all of your FOBs at the same time. Once you do the re-learn procedure, if the fob quits, a simple re-sysn will get it back on line. press LOCK & UNLOCK at the same time and hold it until the horn beeps.
Yes disconnecting the battery for 5-10 min is more than enough time to reset all the electronics.
BC
Re-syncing just wont work. You must re-learn all of your FOBs at the same time. Once you do the re-learn procedure, if the fob quits, a simple re-sysn will get it back on line. press LOCK & UNLOCK at the same time and hold it until the horn beeps.
Yes disconnecting the battery for 5-10 min is more than enough time to reset all the electronics.
BC
Thread Starter
Drifting
Joined: Sep 2001
Posts: 1,651
Likes: 0
From: Ocean County NJ
Ok guys, apparently the passive on/off feature went haywire on my FOB. I would have the passive feature off and would walk away from car after arming and it would beep (as if car alarm was arming) but unlock. I found this out by numerous tests. So I had the other FOB never used stored and just use that now and took the battery out of the other.
Weird, but solved!
Weird, but solved!
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)
Joe Kucinski
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!
Verdad Gallardo
Top 10 Corvettes Coming to Mecum Indy 2026!
Brett Foote
Race Director
Joined: Jul 2005
Posts: 11,308
Likes: 1
From: The Beautiful Greater Bay Area California
Originally Posted by Bill Curlee
If you installed a new battery in the FOB,, you MUST do a FOB relearn procedure. It should be in the owners manusl.
Re-syncing just wont work. You must re-learn all of your FOBs at the same time. Once you do the re-learn procedure, if the fob quits, a simple re-sysn will get it back on line. press LOCK & UNLOCK at the same time and hold it until the horn beeps.
Yes disconnecting the battery for 5-10 min is more than enough time to reset all the electronics.
BC
Re-syncing just wont work. You must re-learn all of your FOBs at the same time. Once you do the re-learn procedure, if the fob quits, a simple re-sysn will get it back on line. press LOCK & UNLOCK at the same time and hold it until the horn beeps.
Yes disconnecting the battery for 5-10 min is more than enough time to reset all the electronics.
BC
Bill to the rescue! 
