C5 Tech Corvette Tech/Performance: LS1 Corvette Technical Info, Internal Engine, External Engine, Tech Topics, Basic Tech, Maintenance, How to Remove & Replace
Sponsored by:
Sponsored by:

Bonehead move # 2

Old Oct 18, 2001 | 01:03 AM
  #1  
C5Longhorn's Avatar
C5Longhorn
Thread Starter
Race Director
25 Year Member
Conversation Starter
All Eyes On Me
 
Joined: Aug 1999
Posts: 15,299
Likes: 33
From: Houston Texas
Default Bonehead move # 2

Well, I made my second bonehead move and cut a corner too tight, scraping my rear passenger rim. I checked the damage and its slight and not very noticeable. However, it did scuff and scratch and scrape off the clearcoat on the rim. Do I have to do anything to the high polish rim? Need to add clearcoat or is it ok as is?

Any help would be appreciated.

Thanks,

Reply
Old Oct 18, 2001 | 08:33 AM
  #2  
C5Longhorn's Avatar
C5Longhorn
Thread Starter
Race Director
25 Year Member
Conversation Starter
All Eyes On Me
 
Joined: Aug 1999
Posts: 15,299
Likes: 33
From: Houston Texas
Default Re: Bonehead move # 2 (rschiltz)

TTT
Reply
Old Oct 18, 2001 | 10:01 AM
  #3  
Paul R's Avatar
Paul R
Drifting
25 Year Member
All Eyes On Me
Liked
Loved
 
Joined: Aug 1999
Posts: 1,593
Likes: 37
From: Altamonte Spgs Florida
Cruise-In I Veteran
Cruise-In II Veteran
Default Re: Bonehead move # 2 (rschiltz)

I wouldn't describe this as a bonehead move, because more of us have done this than you would believe. It is part of using your vette. No car that is used will remain perfect forever.

I wouldn't try to re-clearcoat the damaged section. If the scars are detectable, you can buff them out with a buffing wheel and a dremel. Or contact a wheel refinishing/repair shop if it really bothers you. Keep a good coat of zaino on the wheel and it should be fine.

Or you can do what I did and just replace the wheels with some aftermarkets :D
Reply
Old Oct 18, 2001 | 10:10 AM
  #4  
Scott97's Avatar
Scott97
Melting Slicks
 
Joined: Sep 1999
Posts: 3,292
Likes: 0
From: Round Rock, Texas Texas
Default Re: Bonehead move # 2 (Paul R)

Dang Rick, first you dropped stuff into the black hole and now this! j/k :)

Sounds like its not too bad.

You could always buy my magnesiums from me ;)
Reply
Old Oct 18, 2001 | 10:46 AM
  #5  
chuckster's Avatar
chuckster
Race Director
20 Year Member
 
Joined: Mar 2000
Posts: 17,602
Likes: 20
From: Palm City Florida
Default Re: Bonehead move # 2 (rschiltz)

No prob.
I did it too! :mad:

Just buff it out with a Dremel or by hand and then put a coat of clear nail polish over it to keep it protected. No need to spray clear coat.
Reply
Old Oct 18, 2001 | 11:22 AM
  #6  
glen5839's Avatar
glen5839
Burning Brakes
10 Year Member
 
Joined: Jun 2000
Posts: 798
Likes: 0
From: Houston TX
Default Re: Bonehead move # 2 (rschiltz)

Rick

There's a good repair shop here in Houston near Antione and 34th off of 290. If you want to get it repaired let me know and I'll make a phone call for you.

Reply
Old Oct 18, 2001 | 06:14 PM
  #7  
slogan_98's Avatar
slogan_98
Instructor
 
Joined: Jun 2001
Posts: 206
Likes: 0
Default Re: Bonehead move # 2 (glen5839)

If you are talking about the Wheels America place I didn't think they did very good work.
Steve
Reply
Old Oct 18, 2001 | 06:26 PM
  #8  
Vet-Y2K's Avatar
Vet-Y2K
Instructor
 
Joined: Nov 1999
Posts: 195
Likes: 0
From: Canada
Default Re: Bonehead move # 2 (rschiltz)

I hope it's not true that thinks happen in 3s. Maybe it's time to park it and drive something else untill the third thing happens. :confused: :confused:
Well a rim is okay could have been a lot worst. Just be a little careful for a little while till the bad luck runs its course. :) :seeya


[Modified by Vet-Y2K, 4:26 PM 10/18/2001]
Reply
Corvette Stories

The Best of Corvette for Corvette Enthusiasts

story-0

10 Ugly Corvettes That We Still Kinda Love

 Joe Kucinski
story-1

Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer

 Brett Foote
story-2

10 Things Every Corvette Owner Needs (2026 Edition)

 Michael S. Palmer
story-3

8 Most "Only Corvette Owners Understand" Quirks and Problems

 Pouria Savadkouei
story-4

10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years

 Joe Kucinski
story-5

How Much Horsepower Every Corvette Engine "LOST" in 1972

 Joe Kucinski
story-6

Top 10 DOs and DON'Ts for Protecting Your Convertible Top!

 Michael S. Palmer
story-7

Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!

 Joe Kucinski
story-8

150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter

 Joe Kucinski
story-9

8 Coolest Corvette Pace Cars (and Replicas) of All Time

 Verdad Gallardo
Old Oct 18, 2001 | 07:55 PM
  #9  
C5Longhorn's Avatar
C5Longhorn
Thread Starter
Race Director
25 Year Member
Conversation Starter
All Eyes On Me
 
Joined: Aug 1999
Posts: 15,299
Likes: 33
From: Houston Texas
Default Re: Bonehead move # 2 (Vet-Y2K)

Thanks everyone for the responses. Its not bad enough to warrant repair at a shop but I will try to file it down and add nail polish.

Scott,

What rims are you using now? You must be on your 4th set now :D

Thanks for the help offer Glen.

Reply
Old Oct 18, 2001 | 08:02 PM
  #10  
JWSchmidt3's Avatar
JWSchmidt3
Race Director
 
Joined: Sep 2000
Posts: 11,309
Likes: 0
From: Valley Ranch, Texas
Default Re: Bonehead move # 2 (rschiltz)

Hey Rick, the move wasn't bonehead, but telling the world on the CorvetteForum is. :p: :lol: :lol:
Reply
Old Oct 19, 2001 | 12:57 AM
  #11  
C5Longhorn's Avatar
C5Longhorn
Thread Starter
Race Director
25 Year Member
Conversation Starter
All Eyes On Me
 
Joined: Aug 1999
Posts: 15,299
Likes: 33
From: Houston Texas
Default Re: Bonehead move # 2 (JWSchmidt3)

Yeah, I know but I was worried about whether or not I needed to immediately seal it or not. :confused:

Reply

Get notified of new replies

To Bonehead move # 2



Thread Tools
Search this Thread

All times are GMT -4. The time now is 05:06 AM.

story-0
10 Ugly Corvettes That We Still Kinda Love

Slideshow: 10 ugly Corvettes that we still kinda love.

By Joe Kucinski | 2026-06-03 10:34:17


VIEW MORE
story-1
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer

A lot of money has changed hands at the online auction house over the years.

By Brett Foote | 2026-06-03 10:21:50


VIEW MORE
story-2
10 Things Every Corvette Owner Needs (2026 Edition)

Slideshow: 10 great gifts Corvette enthusiasts actually want for Father's Day!

By Michael S. Palmer | 2026-06-03 15:43:40


VIEW MORE
story-3
8 Most "Only Corvette Owners Understand" Quirks and Problems

Slideshow: These are the quirks, annoyances, and oddly lovable problems that every Corvette owner eventually learns to live with.

By Pouria Savadkouei | 2026-05-28 09:31:39


VIEW MORE
story-4
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years

Slideshow: 10 reasons why the C6 Z06 is still a performance benchmark after 20 years.

By Joe Kucinski | 2026-05-27 17:20:09


VIEW MORE
story-5
How Much Horsepower Every Corvette Engine "LOST" in 1972

Slideshow: How much horsepower every Corvette engine lost in 1972.

By Joe Kucinski | 2026-05-27 16:54:53


VIEW MORE
story-6
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!

Slideshow: How to Protect A Convertible Top: 10 DOs & DON'Ts

By Michael S. Palmer | 2026-04-03 00:00:00


VIEW MORE
story-7
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!

Slideshow: The 10 most explosive Corvettes ever built based on power-to-weight ratio.

By Joe Kucinski | 2026-05-20 07:23:03


VIEW MORE
story-8
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter

Slideshow: From C1 to C8 we compare every Corvette generation by the numbers.

By Joe Kucinski | 2026-05-12 16:54:12


VIEW MORE
story-9
8 Coolest Corvette Pace Cars (and Replicas) of All Time

Slideshow: Some Corvette pace cars became collectible legends, while others perfectly captured the look and attitude of their era.

By Verdad Gallardo | 2026-05-11 09:50:51


VIEW MORE