ABSfixer C1214
Thread Starter
Advanced
Joined: Dec 2004
Posts: 83
Likes: 0
From: Acworth GA
ABSfixer C1214
I just got my EBCM back from ABSFIXER.COM and just finished the install.
Turned the key and NO MORE CODES! I have ABS, Traction control and Active handling back for $158!
I will admit getting the EBCM out was a challenge, especially all 6 screws and both connectors. Helps to remove the air bridge and to have a second set of hands to hold things out of the way. It was easier going back in than coming out.
Turned the key and NO MORE CODES! I have ABS, Traction control and Active handling back for $158!
I will admit getting the EBCM out was a challenge, especially all 6 screws and both connectors. Helps to remove the air bridge and to have a second set of hands to hold things out of the way. It was easier going back in than coming out.
Safety Car
Joined: Jul 2001
Posts: 4,661
Likes: 67
From: Ocean Springs MS
Try this thread. It's about 18 pages about the problem, the causes, and the cures. http://forums.corvetteforum.com/show....php?t=1387486
Thread Starter
Advanced
Joined: Dec 2004
Posts: 83
Likes: 0
From: Acworth GA
I think it is a transistor or similiar. Big trick is getting the unit resealed for life in the engine bay.
I did the door module fix with the relay replacement (
) and I need to do the cold solder joint fix for the dimming HVAC controller. These are much easier, since the units are in-cab.
You would wish that Delphi would have done this right the first time.
Hats off to Brandon.
I did the door module fix with the relay replacement (
) and I need to do the cold solder joint fix for the dimming HVAC controller. These are much easier, since the units are in-cab.You would wish that Delphi would have done this right the first time.
Hats off to Brandon.
