Getting dynoed again today.......TPIS headers installed
Thread Starter
Drifting
Joined: Aug 2000
Posts: 1,386
Likes: 0
Getting dynoed again today.......TPIS headers installed
UPDATE: The graph is now posted. Scroll down........
Well, I've had my TPIS headers on for a few hundred miles now. I'm getting my car dynoed again this afternoon.
My previous dyno was a month ago with Donaldson intake and Corsa touring exhaust (330 RWHP). Since then I've added TPIS long tube headers and that's it. I'll post the results later this evening.......I'm hoping for 337-340 RWHP.
[Modified by 2thDr, 8:58 PM 10/26/2001]
Well, I've had my TPIS headers on for a few hundred miles now. I'm getting my car dynoed again this afternoon.
My previous dyno was a month ago with Donaldson intake and Corsa touring exhaust (330 RWHP). Since then I've added TPIS long tube headers and that's it. I'll post the results later this evening.......I'm hoping for 337-340 RWHP.
[Modified by 2thDr, 8:58 PM 10/26/2001]
Former Vendor
Joined: Nov 2000
Posts: 5,607
Likes: 1
From: Houston TX
Re: Getting dynoed again today.......TPIS headers installed (2thDr)
I'm interested in the dyno # as well. I have the exact same setup as you, except Corsa Pace instead of Touring. I hope that it'll give you some where between 10RWHP and 15RWHP more. :D
Hopefully I'll be able to dyno it tomorrow @ MTI.
Hopefully I'll be able to dyno it tomorrow @ MTI.
Thread Starter
Drifting
Joined: Aug 2000
Posts: 1,386
Likes: 0
Re: Getting dynoed again today.......TPIS headers installed (Bluewasp)
No I don't have any pics. Sorry. I could run out in the garage and take a pic, but I can't get any pics underneath the car, which is probably what you're looking for.
Race Director
Joined: Aug 1999
Posts: 15,466
Likes: 0
From: GARDENA Ca, State Of Konfusion
St. Jude Donor '05
Re: Getting dynoed again today.......TPIS headers installed (2thDr)
I know someone that only picked up 6 hp from the TPIS, but I have heard reports of much larger gains!
[Modified by wallstAL, 9:06 AM 10/26/2001]
[Modified by wallstAL, 9:06 AM 10/26/2001]
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Drifting
Joined: Aug 2000
Posts: 1,386
Likes: 0
Re: Getting dynoed again today.......TPIS headers installed (leanhtuan)
Remember to post the dyno graph, rather than just #'s.
Thanks
-Tuan
Thanks
-Tuan
Former Vendor
Joined: Nov 2000
Posts: 5,607
Likes: 1
From: Houston TX
Re: Getting dynoed again today.......TPIS headers installed (66ImpalaLT1)
If the shop uses a dynojet, bring a floppy and they can save the output for you.
Eric
Eric
Thanks
-Tuan
Race Director
Joined: Aug 1999
Posts: 15,299
Likes: 33
From: Houston Texas
Re: Getting dynoed again today.......TPIS headers installed (leanhtuan)
I'm interested in your results as well. I haven't been able to show a gain on the dyno but think it may have been because of other factors. Good luck.
Thread Starter
Drifting
Joined: Aug 2000
Posts: 1,386
Likes: 0
Re: Getting dynoed again today.......TPIS headers installed (66ImpalaLT1)
Actually, I think I'll just take a picture of the dyno graph with my digital camera and post that. I'm leaving in about 20 minutes to go to the dyno......
[Modified by 2thDr, 2:05 PM 10/26/2001]
[Modified by 2thDr, 2:05 PM 10/26/2001]
Drifting
Joined: Mar 1999
Posts: 1,290
Likes: 0
From: Sarasota, FL
Cruise-In I Veteran
Re: Getting dynoed again today.......TPIS headers installed (2thDr)
That is one strong car if you are running at 330 rwhp with only those mods. I was at 318 rwhp with xpipe/vortex/triflos/GMS maf and 334rwhp after the TPIS install..It wil be interesting to see what u pick up..
Former Vendor
Joined: Nov 2000
Posts: 5,607
Likes: 1
From: Houston TX
Re: Getting dynoed again today.......TPIS headers installed (dmc1007)
That is one strong car if you are running at 330 rwhp with only those mods. I was at 318 rwhp with xpipe/vortex/triflos/GMS maf and 334rwhp after the TPIS install..It wil be interesting to see what u pick up..
I have replaced the stock plugs with NGK TR55 and also added the TPIS LT. Will see what I'll get on the next dyno :D
Former Vendor
Joined: Nov 2000
Posts: 5,607
Likes: 1
From: Houston TX
Re: Getting dynoed again today.......TPIS headers installed (2thDr)
Actually, I think I'll just take a picture of the dyno graph with my digital camera and post that. I'm leaving in about 20 minutes to go to the dyno......
[Modified by 2thDr, 2:05 PM 10/26/2001]
[Modified by 2thDr, 2:05 PM 10/26/2001]
Melting Slicks
Joined: Sep 1999
Posts: 3,292
Likes: 0
From: Round Rock, Texas Texas
Re: Getting dynoed again today.......TPIS headers installed (leanhtuan)
My guess is 7 - 10 RWHP.
The long tubes make more hp on a heads/cam setup.
I'll be dynoing again today as well.
Get off the web and get on over here! :D
The long tubes make more hp on a heads/cam setup.
I'll be dynoing again today as well.
Get off the web and get on over here! :D
Former Vendor
Joined: Nov 2000
Posts: 5,607
Likes: 1
From: Houston TX
Re: Getting dynoed again today.......TPIS headers installed (Scott97)
My guess is 7 - 10 RWHP.
The long tubes make more hp on a heads/cam setup.
I'll be dynoing again today as well.
Get off the web and get on over here! :D
The long tubes make more hp on a heads/cam setup.
I'll be dynoing again today as well.
Get off the web and get on over here! :D
