Driver side fender removal

Reply Subscribe

Thread Tools

Search this Thread

Jun 17, 2008 | 05:41 AM

koldnrg

Thread Starter

Racer

Joined: Feb 2007

Posts: 284

Likes: 30

From: Gordon Nebraska

Driver side fender removal

I just got my new fender from corvetterecycling and it looks great, "had a very deep key mark in the original, and it was cheaper to replace then to repaint" My question is does anyone have a write up or a site that shows how to remove the front driver side fender? I can see most of the attachment points but by looking at the "new" fender I can see there are 2 points that may require the removal of the front bumper? and also some towards the rear, in the door jam area do these require me to remove my door? If anyone has done this kind of swap please chime in and let me know what I am up against, Thanks

Jon

Jun 17, 2008 | 06:09 AM

RobertEarl

Racer

Joined: Mar 2003

Posts: 440

Likes: 7

From: Willow Park Texas

The ones up front are easily gotten to by removing the headlight. The one at the rear you can get at after you remove the fender liner with an extension. Not hard at all to get off and on.

Reb

Jun 17, 2008 | 06:15 AM

koldnrg

Thread Starter

Racer

Joined: Feb 2007

Posts: 284

Likes: 30

From: Gordon Nebraska

alright, thanks, might have to tackle this job today.

Jun 17, 2008 | 06:51 AM

AU N EGL

Team Owner

Joined: Sep 2003

Posts: 43,084

Likes: 33

From: Raleigh / Rolesville NC

the nuts up by the head lights are hard to reach. 10 mm I think vs all the others are small torques screws.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump