Torque Tube Coupler
#1
Drifting
Thread Starter
Member Since: Jul 2002
Location: Corpus Christi Tx.
Posts: 1,329
Likes: 0
Received 8 Likes
on
6 Posts
Torque Tube Coupler
C5/C6 Corvette Six Shooter™ Driveline Coupler. 10mm, Kit #7-1650, 12mm, Kit # 7-1651
http://www.prothane.com/whatsnew.php
Anyone tried this yet ?????
#4
Le Mans Master
Member Since: Feb 2007
Location: Oviedo Florida
Posts: 8,818
Received 1,257 Likes
on
819 Posts
2023 C2 of the Year Finalist - Modified
2021 C2 of the Year Finalist - Modified
2016 C5 of Year Finalist
know about 2 alum. couplers on your drive shaft???
Just a thought.
#6
Racer
run them in front and rear! they are solid allumnium pices with poly bushings inserted to give flex they are really an amazing part for the money i have pics of them on my assemebly, and some close ups too. if you have a carbon drive shaft you will have to mill some additional clearance in the drive shaft hub for the bushing retainer on the coupler, if any one needs this done i can do it on a CNC with a fixture that i made up for mine.
#7
Safety Car
run them in front and rear! they are solid allumnium pices with poly bushings inserted to give flex they are really an amazing part for the money i have pics of them on my assemebly, and some close ups too. if you have a carbon drive shaft you will have to mill some additional clearance in the drive shaft hub for the bushing retainer on the coupler, if any one needs this done i can do it on a CNC with a fixture that i made up for mine.
#8
Drifting
Member Since: Jul 2000
Location: Tallahassee Florida
Posts: 1,314
Received 0 Likes
on
0 Posts
We ran one of these on our race car this season, it looks like a nice piece and we had high hopes for it, unfortunately it lasted not much longer that the stock units (4 race weekends vs. three)
#10
Tech Contributor
I'd like to know more about the nature of the failure, and what type of racing/HP level are you at?
#11
Drifting
Member Since: Jul 2000
Location: Tallahassee Florida
Posts: 1,314
Received 0 Likes
on
0 Posts
The ureathane bushing was distorted and beat out, the bolts then broke due to the movement. I am not saying that the part was no good or a bad design, it just didn't hold up any better than the stock setup.