When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
My luck... :\
Just put the car on coilovers (about 1/2 inch lower than before in the front)...
Piece of metal was on the road... unable to avoid (atleast, safely IMHO) heavy traffic in San Jose.
Dented / put a hole in my header right above where they all merge together.
These are aftermarket dynatech headers. :[
Any way to repair it?
It hasn't collapsed the pipe, and car still runs fine, just can hear the leak.
Exhaust wrap? Some type of jb weld?
Don't want to buy new headers
My luck... :\
Just put the car on coilovers (about 1/2 inch lower than before in the front)...
Piece of metal was on the road... unable to avoid (atleast, safely IMHO) heavy traffic in San Jose.
Dented / put a hole in my header right above where they all merge together.
These are aftermarket dynatech headers. :[
Any way to repair it?
It hasn't collapsed the pipe, and car still runs fine, just can hear the leak.
Exhaust wrap? Some type of jb weld?
Don't want to buy new headers
Your BEST bet is to remove the header and take it to a LOCAL sheet metal shop. They will be ABLE TO CORRECTLY MAKE THE REPAIR! They will reform the damaged tube and properly weld in a patch.
Bill
Dont try ANY of that temp stuff.. It is VERY temporary!