C5 lowering
The following users liked this post:
mrr23 (09-29-2015)
#2
Melting Slicks
c5 lowering
Here is a link to video by Froggy:
The following users liked this post:
mrr23 (09-29-2015)
The following users liked this post:
mrr23 (09-29-2015)
The following users liked this post:
mrr23 (09-29-2015)
#5
Burning Brakes
The following users liked this post:
mrr23 (09-29-2015)
The following users liked this post:
mrr23 (09-29-2015)
#7
Melting Slicks
That write up said to use 18mm wrench on the top nut to keep it from turning but 18mm did not fit mine, it was too small. I ended up having to use a crescent wrench die to lack of tools. It worked though.
The following users liked this post:
mrr23 (09-29-2015)
#8
Melting Slicks
I just read one of the DIY posts on this forum about lowering on stock bolts. Apparently on the rear bolts they are different lengths and if you adjust them both to the same amount of threads showing then you have screwed up your corner weights.I wish I had read that before I lowered mine!!
The following users liked this post:
mrr23 (09-29-2015)
#9
Advanced
Thread Starter
Member Since: Nov 2014
Location: Marion north carolina
Posts: 74
Likes: 0
Received 5 Likes
on
5 Posts
C5 lowering
I just read one of the DIY posts on this forum about lowering on stock bolts. Apparently on the rear bolts they are different lengths and if you adjust them both to the same amount of threads showing then you have screwed up your corner weights.I wish I had read that before I lowered mine!!
The following users liked this post:
mrr23 (09-29-2015)