2003: Question After Running Codes
Thread Starter
Racer
Joined: Jul 2002
Posts: 324
Likes: 0
From: Fort Wayne IN
2003: Question After Running Codes
I noticed that after running a code check (found none) that when I turn my key off after the last module says "no codes", I get a Charge System Fault message. Now if I wait unti the code system goes to the Manual Diagnostic Mode and then turn off the key, the Charge System Faukt does not appear. I'm sure there is no problem, but just wondered if anyone else noticed this when running a code check. Thanks.
Jim
Jim
