Stinger Install at 21MC (Dial Up Beware)
Onto the lift:
Up she goes:
Loosening the old exhaust:
Prying off the old exhaust:
Fresh from the box (they blew these out with shop air to make sure they were clean):
The old stock mufflers and their bad paint job (they really looked bad next to the T-304 stainless Borlas):
Prepped and ready to go on:
The new Borla one-tip (notice that they left on the plastic during installation to protect the tips):
Getting it in place:
Getting it straight (they said it was straight when I SAID it was straight. Then they tack welded the clamps to keep it straight):
And finally, they fired it up (schweet):
Thanks again to John Page, Mike, and the staff at 21MC!!!!
(Look in the General Discussion section...I will post some pics from the shop and the store there)
I'll just say I was happy with it!
The Best of Corvette for Corvette Enthusiasts




Enjoy! :cheers:








