[Z06] ECM replacement
#1
Burning Brakes
Thread Starter
ECM replacement
I believe i tracked down my dropping voltage to the ECM (one of the feeds into the alternator from ECM dropping below 5 volts at idle) and bought a new ECM from Gene Culley. My question is, can i simply have my tuner flash this ECM with my current tune? Or do I need to have a Chevy dealer do an intial flash specific to my VIN etc. Any gotchas I have to watch out for? Any one else replace their ECM and running an aftermarket tune?
Thx,
Pete
Thx,
Pete
#2
Safety Car
Member Since: Oct 2008
Location: Ft. Collins, CO
Posts: 3,964
Likes: 0
Received 14 Likes
on
10 Posts
did Gene asked for your VIN?? I bought an ECM a while back and the seller asked me for the vin number. he flashed it with that vin number and all I did is install it and tune it. your tuner wont be able to do that ( I doubt it)
#3
Burning Brakes
Thread Starter
I supplied my VIN when ordering online, but Gene did say I would need to take it to a dealer for a flash. I wasn't sure if that was required or if I could simply flash it the first time with just HP Tuners. Sounds like I might need to take it to Chevy for an initial flash.