DebRedZR1

If it is the rear window, it won't be that big (ugly!) square thing we have seen in some renderings

DebRedZR1

Psydef

Cool thanks for posting the video.

IMO they should have released the videos in the opposite order. The 1st and 2nd videos revealed a lot more of the car so I kind of expected a bit more in the 3rd and 4th.

The 13th can't come soon enough!!!

BeaZt

Some people like foreplay others don't...if you don't like the videos just wait until one13 and have your way with it.... Lol

GmdVT

looks like the rear looking back as if you were standing by the rear wheel, you can sort of see the tapered window in the upper left, if so it is A LOT more angular than any of the renders have shown.

Rick HendrickAtlanta

nice looking brakes! (at least from this angle)

not08crmanymore

THIS MIGHT BE THE REAR DECK LID but with out the rear fascia on.In my opinion,this video has shown more then any prior video,but still shows more or less nothing that gives the actual look of the car away...3 DAYS!!! Oh,and if that's the actual panel gap,they have some serious work to do to fix that!!
Does the windshield look narrower than that of the c6?

plasboy

In between 8 seconds and 10 seconds it shows a whole piece being lifted but I can't get it to pause there. Can anyone get a still?

CRABBYJ

0:32 rear suspension being assembled.

CRABBYJ

one13thirteen #4 Trailer-Creation now open.

http://www.chevrolet.com/one13thirteen.html

Edit: And YouTube.

WOLF ECHO

I'm thinking hood without front cap, as if someone was standing by right fender looking to front of car. You can see the hood vents, as well as the raised center section.

burtonbl103

This is hood and fender with OUT the dront nose clip installed, he more i look at it

mksz51

Time to lighten up - try decaf tomorrow.

CRABBYJ

Is this just a perspective difference or does this C7 frame above look to be flatter from front to back compared to the C6 frame below. Or the side rails are higher like with the C4 which I doubt they would do? Anyway it would put more mass closer to the ground and lower the center of gravity if the frame front and back were more on plane with the center IMO

BlueOx

It looks flatter but could be perspective. Front still looks like it raises up a lot. Good point about lowered center of gravity, though.

My GUESS is this image below is the front right fender with the double-crease and no nose yet installed.

burtonbl103

Exactly

DREAMERAK

def aluminum, there is a casting being welded to a frame extrusion in the vid.

BlueOx

And for those who might think it is the back end, I submit that the opening shown at the right wouldn't be wide enough at the back to get the targa roof section through.


I also still put a lot of stock in this image as very representative of what we will see at the back end.

B-Myster

I don't think any renderings show that crease in the rear fender area.

This must not be the factory paint job as I'm not seeing the patented orange peel in the reflection.

LT1_E85_Corvette

Well I'm now convinced we don't have a 2x2 (which is OK with me, but would have been cool). I think this video shows a lot, and we will find more as the day goes on. Thanks Chevy for keeping us all interested!