When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Do i want 18's, 19's, or a stock 19/20 setup...that is the question. I see there's a bit of a sale on a set of 18's if im seeing it right. 😎. It's hard trying to figure out all the best tire setups.
Do i want 18's, 19's, or a stock 19/20 setup...that is the question. I see there's a bit of a sale on a set of 18's if im seeing it right. 😎. It's hard trying to figure out all the best tire setups.
Sticks really well without much warming up. My traction control rarely kicks in now. Cup 2 used to be so bad until the tires got some decent heat in them.
Sticks really well without much warming up. My traction control rarely kicks in now. Cup 2 used to be so bad until the tires got some decent heat in them.
Hopefully you can do an aesthetically pleasing front bumper that will also allow dual intercoolers to sit behind them down the road (should people want to retrofit ZR1 coolers or aftermarket).
Hopefully you can do an aesthetically pleasing front bumper that will also allow dual intercoolers to sit behind them down the road (should people want to retrofit ZR1 coolers or aftermarket).
Here's one for inspiration -
I may as well let the cat out of the bag. Project starting next week. Stage 3 with 1” more aggressive will be build into the bumper to cut overall cost on customers.
My quick rendering with phone app. Will utilize ZR1 coolers on the side and center, or similar type.
Last edited by Deity.Motorsports; 03-01-2018 at 10:02 AM.
I may as well let the cat out of the bag. Project starting next week. Stage 3 with 1” more aggressive will be build into the bumper to cut overall cost on customers.
My quick rendering with phone app. Will utilize ZR1 coolers on the side and center, or similar type.
The front holes are too big no? (Famous last words )
Why not use the design from the ZR1 render I posted? It looks clean, purposeful and on point. (Besides no one else has done it)
Because I don't think it's that good looking. How is my rendering not purposeful? Two side intake for coolers and one lower intake for a flat long cooler. Just like the picture you posted but without breaking up the front bumper into so may pockets. One large opening that's divided into usable sections. To me, it's an evolution of the Z06 with one large opening. Just enlarged slightly larger for more coolers.
I may as well let the cat out of the bag. Project starting next week. Stage 3 with 1” more aggressive will be build into the bumper to cut overall cost on customers.
My quick rendering with phone app. Will utilize ZR1 coolers on the side and center, or similar type.
02-20-2018, 12:11 PM
)
