flywheel/pressure plate installation
Thread Starter
Instructor
Joined: Nov 1999
Posts: 189
Likes: 0
flywheel/pressure plate installation
I have a new engine that is INTERNALLY balanced with my SPEC flywheel (there is no bob weight along the circumference of the flywheel). I already have the flywheel on, but was wondering if the pressure plate must be installed in a specific position with the flywheel. There is a purple dot on the pressure plate just outside of the hole that the input shaft goes through. I assume that this is for aligning the flywheel and pressure plate, but I don't know if this even matters for my internally balanced engine. Unfortunately, both the engine shop and the clutch shop are closed for the holidays. Anyone know the answer? Happy New Year, and thanks in advance!
Keith
Keith
