CorvetteForum - Chevrolet Corvette Forum Discussion
0 2025/03/02 10:36:19
0 2025/02/27 07:41:07
0 2025/02/27 07:40:57
0 2025/02/20 07:34:00
0 2025/02/19 14:20:46
0 2025/02/19 14:08:40
0 2025/02/19 14:08:32
0 2025/02/19 14:08:25
0 2025/01/22 08:04:17
3 rings. '65 part, '65 car.
3 rings. '65 part, '65 car.
0 2025/01/22 07:41:51
Regulator already had some kind of nut & bolt repair. I have 2 new reproduction regulators now to be installed.
Regulator already had some kind of nut & bolt repair. I have 2 new reproduction regulators now to be installed.
0 2025/01/22 07:41:45
It turns out it was a vent window regulator washer from a previous repair job. This is the regulator I removed.
It turns out it was a vent window regulator washer from a previous repair job. This is the regulator I removed.
0 2025/01/22 07:41:38
0 2025/01/08 11:55:40
0 2024/11/09 14:34:50
I use Amsoil 10w40 Premium Protection motor oil.
I use Amsoil 10w40 Premium Protection motor oil.
0 2024/11/09 14:34:41
0 2024/10/20 11:41:13
0 2024/10/20 11:41:07
0 2024/10/20 11:41:01
Hole in my floor mat after 80,000 miles. lol.
Hole in my floor mat after 80,000 miles. lol.
0 2024/10/03 07:40:07
0 2024/10/03 07:39:31
I don't know about the op car, but this is my daily driver from early spring to late fall. Sooner or later you get caught in the rain. lol.
I don't know about the op car, but this is my daily driver from early spring to late fall. Sooner or later you get caught in the rain. lol.
0 2024/10/03 07:29:37
I could not find the Rod to Main Cylinder Clearance spec in the Service Operations section in the manual. But it looks like if you have at least 1/4" clearance your good to go. It did not say where or how to check the clearance.
I could not find the Rod to Main Cylinder Clearance spec in the Service Operations section in the manual. But it looks like if you have at least 1/4" clearance your good to go. It did not say where or how to check the clearance.
0 2024/09/11 07:37:36
0 2024/09/11 07:37:31
0 2024/08/30 15:03:56
0 2024/08/19 10:07:04
0 2024/08/19 10:06:54
0 2024/08/18 08:42:48
0 2024/08/18 08:42:42
0 2024/07/13 16:10:24
0 2024/07/13 16:05:41
I made this with a 12v spring loaded button
I made this with a 12v spring loaded button
0 2024/07/13 16:02:47
I could not get my phone in for a good straight angle on the picture.
I could not get my phone in for a good straight angle on the picture.
0 2024/05/23 14:36:39
0 2024/04/12 11:01:14
shows large black wire from horn relay to altenator.
shows large black wire from horn relay to altenator.
0 2024/03/31 12:46:02
2 black ground wires attached to horn relay base. The large black wire goes back to the alt. ground terminal and the small black jumper wire goes from the horn relay base to the voltage regulator base.
2 black ground wires attached to horn relay base. The large black wire goes back to the alt. ground terminal and the small black jumper wire goes from the horn relay base to the voltage regulator base.
0 2024/03/31 12:45:54
0 2024/02/04 10:06:31
0 2024/02/04 10:06:23
0 2024/02/04 09:59:56
car and windows are drity from sitting in storage since last fall.
car and windows are drity from sitting in storage since last fall.
0 2024/02/04 09:55:14
SAFETY PLATE LOF Solid Tempered A52 IC Is this tinted glass?
SAFETY PLATE LOF Solid Tempered A52 IC Is this tinted glass?
0 2024/02/04 09:45:31