I used to have to slam my door every time to get it to close all of the way. I also had excessive wind noise from a window which wouldn\’t seal properly. One day I decided I was going to get serious and fix the problem once and for all. I had already replaced the […] More »

How to Adjust your Early C4 TPS and Idle Speed by Lars Grimsrud SVE Automotive Restoration Musclecar, Collector & Exotic Auto Repair & Restoration Broomfield, CO Rev. New 6-15-00 This tech paper will discuss the procedure for correct adjustment of the Minimum Idle Speed and for adjustment of the Throttle Position Switch (TPS) on the […] More »

Most instruction manuals indicate that you should place the Master Cylinder in a vise and then use a dowel rod to press on the plunger to bleed the air out of the Master Cylinder. I found an easier way is to bleed the air out of the system backwards. Supplies: Fittings for bleeding hose (usually […] More »

This is not MY tech tip in any way. This is something that I stumbled across on the corvetteforum, and thought it would be useful here. Simply click on the links. Change your fuel filter, page 1. Change your fuel filter, page 1. Thanks to, lord vette, for the original post! -Sheppe Pharis (aka 92BAV)

Problem For C4 Corvettes with dual fans, the Aux Fan Sw only controls the auxiliary fan. The ECM controls only the main fan. When a low temperature Aux Fan Sw is installed to compliment a low temperature thermostat only the auxiliary fan comes On at a lower temperature; the main fan still comes On at […] More »

Well just a free mod you can do to your air box. Invloves cutting a massive hole in the box so more air can come through it. Seems to me like it does nothing except allow air to enter easily but I don\’t know if it allows MORE air to come in. Well install is […] More »

I\’ve been piddling around with a fix for this, because I\’ve seen a bunch of posts on this topic. I used a can of black Plastikote rubber coating, and cut it down with thinner until it had a paint-like consistency. I then used my airbrush and compressor to spray several coats on spare pieces of […] More »