Cross over setting
Thread Starter
Melting Slicks
Joined: Jul 2015
Posts: 2,313
Likes: 233
From: Round Rock Texas
Cross over setting
I have upgraded the speakers in door and rears to ts a878 and ts g520. Now my kenwood kmr-d372bt now the radio has these setting in the setup.
xover
tweeter frq 1khz to 12.5khz
front hpf 30hz to 250hz
slope -60db to -24db
Rear also has these setting.
Question is what should these be set at?
Also I ask about low volume at rear speakers this week when off will try and adjust pots on roem vet 1 a little better.
Thanks for any ideas
xover
tweeter frq 1khz to 12.5khz
front hpf 30hz to 250hz
slope -60db to -24db
Rear also has these setting.
Question is what should these be set at?
Also I ask about low volume at rear speakers this week when off will try and adjust pots on roem vet 1 a little better.
Thanks for any ideas
Melting Slicks
Joined: Sep 2004
Posts: 2,847
Likes: 439
From: Spring Texas
You need to leave the front cross over off since it also feeds the factory sub amp. The 3.5" has a built in high pass capacitor.
The rear can be set around 50 or 60 hz.
The rear can be set around 50 or 60 hz.
Last edited by VinceC5; Apr 2, 2019 at 10:40 AM.
Thread Starter
Melting Slicks
Joined: Jul 2015
Posts: 2,313
Likes: 233
From: Round Rock Texas
Melting Slicks
Joined: Sep 2004
Posts: 2,847
Likes: 439
From: Spring Texas
Thread Starter
Melting Slicks
Joined: Jul 2015
Posts: 2,313
Likes: 233
From: Round Rock Texas
Hey thanks for the help and the diagram make sense now. When I am off this week going to try and adjust roem vet1 like this.
https://www.corvetteforum.com/forums...roem-vet1.html
See if this helps equalize the sound between front and back. Could be like some have said the base is over powering everthing
https://www.corvetteforum.com/forums...roem-vet1.html
See if this helps equalize the sound between front and back. Could be like some have said the base is over powering everthing
Thread Starter
Melting Slicks
Joined: Jul 2015
Posts: 2,313
Likes: 233
From: Round Rock Texas
