Pillar Post
Burning Brakes
Joined: Mar 2003
Posts: 891
Likes: 165
From: Oswego IL
I replaced them on my father's 75. Not too bad. I ordered the pieces from Wilcox. I think they are made by Corvette America. There are I believe 2 screws and some plastic velcro tabs that hold them in place. You will need to take the center cover down as well (just screws hold it in place) as the outer pillars extend under the center cover. The new pieces did not come pre-drilled, so I had to drill holes and then use an awl to line up the hole with the stock screw holes. It took a little tweaking here and there, but with a little patience it will be a pretty easy replacement.
Team Owner
Joined: Jun 2000
Posts: 38,923
Likes: 1,481
From: Southbound
Cruise-In II Veteran
Not much to it. Got the AIM? Picture of the whole set up in the AIM.
My advice is to buy the best quality replacements you can locate. Lots of folks report poor fit with the cheaper versions.
My advice is to buy the best quality replacements you can locate. Lots of folks report poor fit with the cheaper versions.
