When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 70 vette. I was just looking at it tonight and it looks like the molding is pulled up. It may have gotten caught on my cover and I did not notice it. The molding I am talking about is attached to the front quarter panel at the windshield. My question is how is it attached? Is it adjustable or is it part of the quarter? Is is adjustable without pulling anything?
If you are talking about the part in my pic, there are 2 'U' shaped clips that slide onto the fender and hold the trim piece in place. You can slide the trim piece (a little) in either direction for proper clearances. Perhaps yours is bent a little on the back side flange ... if so, you can easily slide the trim piece off, straighten it out, and reinstall.
Last edited by 70Yellowbird; Sep 25, 2008 at 12:25 PM.
This part is a PITA to deal with because that clip is difficult to get to. I know someone who ended cracking their windshield trying to install these, so go slow and be careful.
Glenn
I believe removing the wiper door makes access easier for this piece, and if you are cracking windshields putting this piece on the fender, YOU DEFINITELY are doing something wrong......................
Hi 70D,
Lot's of good advice!! No one has mentioned yet that the trim comes off the clips by sliding it forward, ... away from the windshield. You have to be VERY careful to not scratch the paint on the fender.
Regards,
Alan